EMG x Noveske NSR Gen 4 M-LOK Handguard for M4 Series Airsoft AEGs
(Length: 15" / Flat Dark Earth)

"I believe my review will be very Effective

If you’re getting this for a GBBR (preferably any noveske rifle whether it’s VFC or TM
I want to advise before hand that the
- screw sizes are different (all 6)
- the diameter of the handguard is bigger than the default one
- and the build does allow you to keep that gas block. It is easily removable the only trouble is do you have the right tools for the Job. I’m not saying this rail is impossible to install but it take a process.

I have a noveske N4 tan I’m currently in the process of switching a 9” to a 9.75” when I recieved it. It came well packaged like a can of biscuits. I had to grab my dad drill gun and a #10 drill bit to make the holes a little bit open for the original gbbr NSR screws to go in they fit nice however remember the diameter difference I said before so if it’s not tight then I’ll make a trip to home depot some day. I’m currently having trouble with the muzzle. I bought a dead air mock suppressor and it came with a flash hider. I’m gonna warn y’all in advance if you’re ever nodding your rifle never tighten screws just keep em snugged. I’m suffering because I can’t take that flash hider off and in order to take out the gas block and install these rails the muzzle and devices have to be removed. I wanna cry but nah I’ll just need to find some vice grips.

Oh yeah and I’m possibly am going to have to route off the back bottom edge so the upper and lower receivers don’t conflicted with each other when removing the back pin.

If you have an AEG I don’t have information on but for Tokyo Marui GBBR take this advice before you make a choice to buy

5 stars because it’s not and Evike problem they are just airsoft retail.

"This review is for the 15 inch FDE variant.

This handguard is really nice. Nice matte coating, tons of mlok on the 7 sides, full length top rail. A barrel nut is included, along with 4 shims (2 skinny, 2 thick) to get the angling right for your receiver. It's held on to the barrel nut by 6 hex screws, 2.5mm Allen key. The paint on these is weak, which creates a nice worn effect. In between the second to last and last space of mlok is a spacer to hold the end of the outer barrel more stationary. On the receiver end, there is a small tab to align it with... Something. The Gen 4 receivers from EMG don't have the corresponding notch, so I can only assume. For a standard tm spec receiver, you may have to dremel away a portion of the gas tube holder. Speaking of gas tubes, this is NOT cut for a gas tube. Not that it matters for airsoft, but it's kind of annoying. Other than that, it's a beautiful handguard and I recommend it for anyone building a rifle with a 16 inch barrel.

"This 15" EMG Noveske Gen 4 RIS M-Lok handguard is a very nice piece. The quality is top notch. However, this does not fit the KWA LM4.