GATE Airsoft PicoSSR 3 MOSFET Unit

"Honestly these should be standard in all aegs (which I guess some manufacturers are trying to do their own unique mosfet configurations). I use these in efficiency builds with stock or 16:1 gears with torquey af motors. Wiring these in stock wiring isn't difficult. You can put it in 2 configurations which I appreciate since keeping one trigger wire doesnt change the length of the wires too much, although usually I do full trigger wire replacement with the signal wire.

Prep was easy enough considering I forget to follow pro soldering tips. I used helping hands to hold the mosfet from one side, drop a tiny drop of flux, then add small dot of solder, then flux the signal or negative wire then add solder to the ends of those, then while the solder on the board is still semi-hot, melt the the solder and insert the wire into it then blow so it cools in place quickly. I haven't fried any of these boards yet and haven't had any failures using 11.1v lipos. I highly recommend these and also the nanoasr (I used those in my personal aegs)

"I fried mine.
.
Be careful. Know how to solder and have a good iron. Prep the surfaces, they're slick. Let the board cool between the required 3 solders. It is super small. You can solder it in line and install the supplied shrink wrap. The second one went fine.

"SUPER SMALL!! LESS THAN 1 INCH!! works awesome, super small and compact, was able to fit it inside my gearbox shell right behind the spur gear.