Strike Industries G4 Mass Driver Slide Mounted Compensator for Glock Gen 4 Pistols
(Type: Standard / Glock 17)

Product Description

Features

• Precision CNC machined steel construction
• No threaded barrel needed
• Matches with width of the slide, it can be used with open holsters, no special holster needed
• Counter recoil design, as the slide moves back the comp moves forward to reduce felt recoil
• Eliminates the need for threaded barrels. 50 State Legal
• Blended, no snag profile
• No permanent modification of weapon required
• Contours with slide dimensions to be compatible with most open-bottom holsters

The Strike Industries Mass Driver compensator represents a quantum leap in compensator design. Current designs have largely been unchanged since the 1930s. Its about time for something revolutionary. The Mass Driver name is inspired by the idea of theoretical mass driver engines in space travel. By ejecting mass, an equal and opposite reaction is generated propelling the space vehicle forward.

The Strike Industries Mass Driver compensator represents a quantum leap in compensator design. Current designs have largely been unchanged since the 1930s. Its about time for something revolutionary. The Mass Driver name is inspired by the idea of theoretical mass driver engines in space travel. By ejecting mass, an equal and opposite reaction is generated propelling the space vehicle forward. The Mass Driver Compensator is driven by the hot gasses expelled through the barrel after the round is discharged, and acts as a counter balance system to attenuate mechanical recoil. Barrel mounted compensators add reciprocating mass and increase the moment of inertia to the operating system, which can have a negative effect on reliable cycling of recoil operated handguns. By separating the compensator from the operating components after ignition, the MD comp allows for close to stock cyclic speeds, and reduces reciprocating mass.

Manufacturer: Strike Industries

For use in GLOCK pistols ONLY
Compatible with fourth generation G17 and G19 only. Not compatible with Gen 1-3 or Gen 5 Glocks.
Recommended torque value for guide rod nut 25 lbs/in.
Note:
Thread Locker strongly recommended for all screws. Gunsmith or armorer installation recommended. Product tested with factory GLOCK components. Performance may vary when using third party party GLOCK components. Consult with a local gunsmith for any custom modification while use with this product.

Product Videos