Contact Us Tel:(626) 286-0360 Store Locations
Phone Support M-F 7am-5pm PST
Browse by Type or Category
MAP Discounts 11/25 - 12/6 + Epic Deals and Free Shipping for Orders over $149!

Matrix DIY Retention Kit for Bump / High Speed Airsoft Helmets - Tan

4 Customer Reviews

by Keith O. on 10/22/2015
"Works GREAT !
Looks good !
Not as hard to install as most insist.
I use it to route my Go-pro power/fan cable and support my external power supply for Go-pro. Also attach my Elite Force Kill rag to the top for easy deployment ,
by MARK P. on 03/27/2015
"BEST add on for my PJs. EXCELLENT retention for lights~gear~situational camo while still allowing for patch placement on the helmet. When it's in stock, snatch 1 up for each dome piece you own. Priceless.
by Brendan W. on 03/10/2021
"The quality of the shock cord is good and the length of the cord is more than enough. The only complaint I have is that there are no instructions to show how to do it properly.
by Zach P. on 05/05/2017
"Just got this for my Emerson Bump Type Tactical Airsoft Helmet (BJ Type / Advanced), and it works really well! Feeding the bungee through was a snap and even after tightening it down and looping over my GoPro External Battery Pouch, I still had a LOT of spare bungee (Around 8 inches). My only complaint was attempting to feed the bungee through the Retention Clip. The last hole you feed it through required two people, one armed with needle nose pliers. The hole was tiny and we struggled to get both bungee cords through it. It's not going anywhere for a LONG time!

TL;DR Looks and works great with a lot of bungee to spare. A bit tough to feed bungee through the Retention Clip at the end.