Contact Us Tel:(626) 286-0360 Store Locations
Phone Support M-F 7am-5pm PST
Browse by Type or Category
Free Shipping for Orders over $149. EPIC DEALS released daily!

Angel Custom VSR-10 MAX Stainless Steel Cylinder Set - SP170

9 Customer Reviews

by Tobey, S. on 07/13/2022
"Bumped our Cyma Vsr 10 up to 450 shooting 32bbs and easyily installed!
by Eric C. on 03/08/2020
"Just finished testing this kit.
the kit drops into CYMA, JG and HFC with no modification required. Tested about 10 VSR-10
Some models the pull is a little rough but I think that's to the nylon cylinder rings in the rifles not being standardized in size. (deviation between different brands) The pull is going to be harder on models with a hard spring.

But in each case I was able to install the kit and fire it without any special modification or marring to any of the finish.
by Wayne H. on 12/25/2019
"Looks great, decent packaging and appear high quality.

Works on my CYMA VSR-10 perfect!
by Sam J. on 12/20/2019
"Great quality kit that works well! All parts are much more smoother and reinforced than stock parts.
by Clifford C. on 10/05/2019
"if you are looking for a cylinder set for your VSR10 go for it!
Drops in my JG BAR-10 and works like a charm!
by Justice D. on 02/13/2013
"Fit great in my JG bar 10, I didnt use the piston because i have an action army zero trigger that came with a piston, but the spring and spring guide work great as well. Has a smooth pull and easy return. And for the guy that said it was to long it actually isn't, just get a towel and wrap it around the cylinder head, use a vise grip and twist it slowly until the washer is no longer showing, then it will fit perfectly. (i thought the same thing at first)
by Joe S. on 07/16/2013
"Fit good in my JG G-spec. The Cylinder head was slightly too long, though and pushed the bb out of the hop up, causing it to roll out the barrel if the rifle was pointed down. To fix this I just used a file to down the tip of the nozzle a little bit. Works great now!!! A very nice drop in upgrade, but it was a little too long for my receiver and the cylinder is a little slim.
by Matthew P. on 02/12/2013
"Right, fantastic piece of kit. I purchased this to go with a laylax pss10 zero trigger unit on my JG bar 10 gspec and it fits the reciever well for diameter. The only problem is that the cylinder head is too long by a couple of mils, which is a shame, as the construction is awesome. This is quicky remedied by swapping out for the stock head, but that leaves the problem of the piston, which wont fit unless you drill out the stock head to fit.
Otherwise the build is awesome. The cylinder glides smooth as silk, and the coating wont scratch off as its imbedded in the steel of the cylinder.
by David K. on 06/14/2020
"After some light use, the head of the piston completely fell apart, the plastic tip is in multiple pieces and the foam/rubber bit at the end is also ripped. In addition the body of the bolt is warped slightly so that it doesn't fit in the receiver of my gun. I would not recommend this product.