Matrix Steel Precision AK / SVD Type Tactical Scope Mount Base

"It fits perfectly on a&k svd and tried putting on lct ak74 and it fits perfectly. Just a side note the nut on bottom of mount you have to adjust it.

"for anyone wondering this works great with the CYMA Standard SVU Airsoft AEG Bullpup Sniper Rifle. there is no shaking and it feels very secure after a few adjustments

"Works fine on my E&L AK-74MN. Just tighten it up and use the clamp. Would recommend.

"this is one of the only rails that fit on LCT AS VAL/ VSS

"Does the job. It works on my E&L AK74M. Only thing I needed to do was read the directions on the box and tighten down the nut until the lever locks the dovetail mount securely. You'll see that the nut has notches to adjust for the mounting base on the AK receiver.

"This is my favorite optic mount has snug fit with great looks.

"This scope mount went perfectly on my Cyma vss, although it was a tiny bit off center, over I was extremely impressed in the entire build quality as it is very good. It’s also long enough where it can hold a scope, it’s size in the pictures don’t give it enough justice on its size.

"Great scope mount. For the few people that run AS VAL, VSS Vintorez, or the variants, this scope is the only scope mount on the market that works for these platforms.

"If you are looking for a budget dovetail mount for your ak this a gem it holds zero very well,and is adjustable for different dovetail size as most dovetail rails vary slightly

"Great optic mount! It is slightly off center for an svd, so more zeroing must be done for it to work properly. Im sure it works well on a standard ak receiver.

"The mount is very solid and if you adjust it properly it doesn't wobble at all. there is a line where the steel rubs the adjustment screw but I don't think it could possibly cause any issues

"Giving the best rating I can. Awesome full steel product, fully adjustable. Anybody saying it wobbles and falls off likely just doesn't know how to adjust AK mounts to fit. Definitely worth the money and decent quality.

"Fits on my LCT sr-3m, however do note that the rail doesn't align with the iron sights perfectly and will sit to the right a bit (about 3mm). Quality is adequate for the price.

"Very nice mount for the price. Just pinch the center and rotate lever to the left, let go (the nut should lock down) then rotate right. Repeat until tight enough to barely slide on. Once you get it right, it should lock down using the lever with no wobble. I had to mount the rail backward to accommodate the factory rear sight.

"With a little bit of trial and error, this mount fits perfectly on my LCT AK-74M. It lines up almost perfectly with the rifle, and has absolutely no wobble.