Guarder Aluminum Slide for Tokyo Marui, WE, KJW HI-CAPA 4.3 Series Airsoft GBB
(INFINITY)

"Very high quality.
The finish is very matte, but doesnt contrast very much from the "satin" finish of the Marui frame.

Everything dropped right in and fits well.

Only problem i ran into was when i would fully tighten the rear sight screw the loading nozzle will get stuck in the retracted position. My solution was to apply blue loctite to the screw and not tighten all the way.

Follow the instructions provided and you should have no issues!

"I bought this slide for my tm 4.3 expecting some sort of fitment required. To my surprise there was actually none. The only con is that the blowback unit fits very tight inside and does not "drop in" - you need to push hard to get it in and to remove it again you need to knock it out from the top of the slide. I tried both the stock tm blowback unit and a uac lightweight blowback unit and they both fit tightly. The rear sight dropped in perfectly and the front sight obviously required some sanding like all aftermarket slides. I have previously owned "higher quality" airsoft masterpiece slides but for the $75 price point guarder is not a bad choice. The slide fits perfectly on the rails with little to no wobble and has a nice matte black finish.

"This slide fit my KJW kp05 without any modification, the fit is near perfect with very little play. It did not fit on my WE MEU however (the rails on the we were too wide and a little tall).

Blow back units require modification to fit (thus the four star rating)
Also rear sight did not swap over from my KJW, which may be something to consider if youre going to buy this.

Very satisfied with my purchase.
Would recommend to people with KJW hi capas
(so long as they have the skillset to modify their blow back unit and modify their rear sight)