Contact Us Tel:(626) 286-0360 Store Locations
AirsoftAirsoftFishing FishingAir GunAir GunTCGTCGEventsEvents
Phone Support M-F 7am-5pm PST
0
Cart
Browse by Type or Category
Trusted by Millions of Airsoft Players Since 2001
Home » Airsoft Accessories, Attachments & Parts » AEG Internal Parts » MOSFET

XCORTECH XET304u Airsoft Mosfet

ID: 50875 (XET304U)
XA000304R001
Tap or click above to open expanded view
Xcortech

$11.00

MAP ProtectedExempt From Coupons
The manufacturer of this product enforces a strict minimum advertised price (MAP) policy which excludes this product from any additional discount coupon codes. This item, however, may qualify for free shipping.

Description

Reviews

Find in Store

Product Description

Features:

  • Hi-Power dual mosfet driver
  • Built-in circuit protection to avoid mosfet suffered BEMF (Back Electromotive Force) damage
  • Mosfet driver designed to increase trigger response while also reducing the amount of heat generated
  • Can be used with the XT-60 connector to reduce impedance
  • Low internal resistance (in parallel): 0.0014 OHMS
  • Included heat shrink tubing
Maximum Input Voltage: 30V
Maximum Current: 200A
Dimensions: 30mm x 15mm
Compatibility: For all Airsoft AEG gearboxes

Manufacturer: XCORTECH

3 Customer Reviews

(Write a review)

by Michael F. on 08/04/2017
"Good mosfet, I have used two so far and they both work great. They do exactly what they should - increase the trigger response and protect the trigger contacts. It is easy to solder in. It comes with heatshrink but it does not come with the smaller gauge wire needed for the trigger contacts. Using deans and 16 awg wire it bumped up my rate of fire using a 7.4v lipo by about 5 bbs per second or so, maybe more.
by Vince E. on 08/10/2020
"using 11.1V lipo, #120 spring, matrix high torque motor magnum motor, inside a TM P90. Handles the voltage and motor very well. Trigger response is almost instant. No more arching of my contacts. Took away one star because the 2 of the through-holes for the wiring was not properly drilled out. One of those holes was the trigger wire and I did note have a drill bit small enough. I had to solder the wire on top of the pad instead of going through the board. Other than that, good product, 4/5 stars.
by kyle R. on 08/17/2015
"Shorted out on a 14.8v lipo but it should be able to handle an 11.1

Have an urgent question about this item? Contact us, our resident experts are standing by to answer your questions!

Warning: California's Proposition 65

Did you find this product somewhere else for cheaper? Request a price match.

Customers who bought this also purchased

Parts and accessories may not be compatible with the product displayed on this page.For compatibility, please verify details on the product description page.

Xcortech