LCT Airsoft Z Series ZB-13 Aluminum Side Mount Rail for AK Series Airsoft Rifles

"Quality construction, decent finish, the scope mount is BIG or at least bigger than I thought it would be.

Almost spans the length of my CYMA AK105 dust cover but that's fine, more room for optics.

As I mentioned it fits fine on a CYMA AK105 so I'm assuming you can use it on other CYMA AKs with a side mount beside the 74u models simply because the length of the mount will hit the rear sight.

All in all: A really good piece of replica Zenitco hardware!

"Surprisingly easy to install, very stable once properly tightened. Fits on my AK-74MN pretty damn well without hurting my wallet too badly. Strongly recommend

"Out of the box it is incompatible with E&L. However, it's more certainly designed with LCT and similar models.

I will say that even if I had to use a steel riffling/rasping file on the lower edge for over 30 minutes to get it to agree with the E&L dovetail there are ways to retain it down to remove wobble. Pic rails are good; I mean you can't mess that up.

The hex screw set up is very similar to Zenitco B-13. There's a bigger 3mm that can dictate how tight the lever will be. However there's smaller (1.5mm?) grub screw that helps set in that setting. To eliminate wobble there's a 2.5mm grub screw towards the rear of the B13 that will tighten down.

Hey it works after some modification for E&L. I can't be too mad.

"Bought for my LCT AK-74MN, and it fits well. Won't slide up all the way on the rail (no clue if intentional or not) but still works as is. Fits super tight, however, and while you CAN access the battery and dust cover with it on, it isn't recommended and feels like I'd have to un-wedge it from the rifle with a flat head to release it. Looking for solutions, or might get it off and replace with B-33. If I can take it off easier, easy 5 since it's cheap, and does what it's supposed to.