ID: 30628 (BAT-PEQ15wLipo-BK)
Hover or touch above to zoom
This is a replica of the modern PEQ15 laser aiming device employed by elite units of the US Military. A visible red laser is pre-installed into this unit. The Beta Project PEQ-15 is made from high impact polymer and comes with sticker labels to properly decorate this incredibly detailed display piece. The Beta Project PEQ-15 unit will provide you the "Special Force" look without adding too much weight to your rifle.Features:Realistic Finish and high quality constructionBuilt in working Laser aiming system with switchAN/PEQ-15 Battery Case with 11.1V 1300mAh 20C Lithium BatteryCompatible with 1400mAh 9.6V / 10.8V NiMh Custom batteriesWeaver Rail Ready. Fits all standard 20mm railsPlug type:
Small TamiyaCharging plug type:
BMS / XH 4-Pin Charging ConnectorSpecifications:
11.1 V / 1300 mAhOutput:
20C - Continuous / 40C - BurstCharger:
Not Included. Lithium Polymer / Li-Poly Chargers Only (BMS / XH 4-Pin Charging Connector)Application:
To power Airsoft AEG guns. To increase rate of fire, pull high power springs, increase trigger response time, and to improve the over-all clean look of your AEG.Manufacturer:
GROUND SHIPPING ONLY NOTICE: Due to US DOT and IATA shipping regulations, batteries shipping Air must have a charge of less than 30%. A lithium polymer battery in this state of charge for long periods of time will become damaged. For this reason, Evike.com will not be shipping batteries via Air shipping methods. This includes all international destinations outside the continental U.S. You will only be presented with ground based shipping options if your order contains a lithium battery.
(Write a review)
"Not impressed, $80 for a battery & case that don't fit properly. The wire for the battery didn't fit through the opening in the case. If I have to rebuild something to make it work, that's fine, unless it's suppose to fit to begin with. I am paying to correct other peoples work.
-Looks good on the weapon
-Lots of details
-The entrance for the battery cable can be adjusted so that the cable goes almost directely into the weapon, leaving the cable very little exposed.
-The battery is pritty complicated to remove. The box opens with 3 screws, and it takes some time to allign them with the nut on the inside
-The forementioned nuts that the screws go into are not well fitted. When you open the box, they tend to fall out, and you are quite likely to loose them in the field
-The laser is realy weak, as well as it being in the wrong place, and it is imposible to sight the laser in.
If you want a nice PEQ to hide the battery away, this is a fairly good buy, but if you want something more than a cheap plastic box, i would rather buy a replica peq without the battery compartment, and then hide the battery in the stock, or inside the rail.
Discuss about Matrix AN/PEQ-15 Case w/ 11.1V Lipoly Battery & Laser Sight (Black) with your friends and fellow Evike.com shoppers!
Comment or answer questions for a chance to win awesome prizes.
Details can be found on the Evike.com Facebook page.
Remember to check "Also post on Facebook" to qualify for the giveaways!
Have an urgent question about this item? We monitor these comments daily, but it may be faster to email us directly or call us at (626) 286-0360. Our resident experts are standing by to answer your questions!