Contact Us (626) 286-0360 Store Locations
Extended Phone Support Hours 7am-7pm PST
Browse by Type or Category
Airsoft Season! SAVE 18% with coupon code: SUMMER2018 (Exclude MAP and SALE Items)

Angel Custom Neo 1-piece Hopup Unit for VSR-10 Airsoft Sniper Rifles

5 Customer Reviews

by David H. on 05/04/2018
"Sorry, I need to correct some things about my previous review.

-the hopup curve was probably ok size, I was just using a flat bucking so it wasn't compatible.
-my copy was probably just missing a piece to keep the hopup pin in.
by Christopher H. on 10/20/2016
"I install this chamber on my Echo 1 PSR and works great, slightly tight fit when installing inside the outter barrel, but nothing to worry about, increase grouping and accuracy, great combination with the wolverine bolt, wich im currently using.
by Brendan M. on 10/03/2013
"It is okay. It is lacking a nub. I put a random green piece (came in the package) that was smaller (didn't realize) than a nub to push on the bucking. It gave greatly increased accuracy by 95%! Make sure that you install the O-Rings. I did not realize where the O-Rings were suppose to go, let's just say bad things happen to good people if you don't install them.

Since I put the green nub piece in the gun has little to no hop but I am sure if I had a proper nub in the chamber it would be working flawlessly. Gives excellent compression with the AEG barrel and hop up rubber (REAPS).

I will give further analysis on the Neo 1 chamber once I get a chance to take my VSR (body threading is stripped together) apart.
by Dion F. on 08/25/2013
"This hopup will not fit a well mb10 outer barrel. You will need to replace the outer barrel to fit any of the WELL sniper rifles in order to use this hopup. It was not a total waste of money. Just need to have the right outer barrel to fit it.
by David H. on 04/21/2018
"So many issues with this thing.
1. the window isn't centered and cuts off 1mm of your window, giving you only 3mm to hop.
2. the description isn't clear, but it has 2 hopup arms. so it's basically a PDI clone. This design isn't good because it's extremely hard to adjust 2 arms once you put it together. It's much better to have just one arm and one screw.
3. the pin that holds the arms in place doesn't stay, and you have to tape it on.
4. the hopup curve (that holds the nub) is so small, that if you put on any nub (including the one that came with it), it doesn't even reach your BB. WT*, did they even test this?
5. no instructions, so I had to go online to watch a tutorial on a PDI chamber.
Looks like someone returned mine, because the coating was scratched and came part assembled. Looks like it's going back again.