Low Profile Bi-Direction Claw Mount for G3 / MP5 / H&K Series Rifles by UTG

"Fits VFC G3 well.
Nothing else to really say.

"Doesn’t quite fit my LCT LC3, or at least I haven’t been able to make it hold centrally on mine. It’ll stay on but will most likely be off centered a bit

"This claw mount needed extensive dremel work to even come close to fitting a standard mp5 replica. It looks like they basically forgot to machine out the tabs on one side, so tightening the opposite side just pulls the unit off the gun, instead of tightening it down. Save yourself a headache and get a better mount the first time.

"Fits, but barely works. I had to machine the last two rails off of mine to get it to fit properly onto my genuine TM Mp5. After that, it holds, but its hard to get level. furthermore the screws that tighten it down were very poorly made. I couldnt figure out if they were supposed to be metric or inch at first because the hex slots had giant burrs inside them preventing me from getting a hex key inside.

also, worst of all. no matter how much I tighten or shim this sight rail, it gets moved easily by any light knocking around. ruining my zero.

buy something else if you plan on actually using the optic you mount.

"Bought for Classic Army G3. With a lot of effort, I can get it to sit on alright, but it seems that it's just a little narrow and you can't tighten both sides down at once. As a result, the scope is a little crooked- not very noticeably so, but once you see it, you can't stop noticing it. You also have to crank up the windage to bring the scope back to zero. Also, stupid non-metric hex-screws ugggghhh.

Maybe it fits fine on a real-steel G3, but I would not really recommend for airsoft.

PS. I'll give it a try with the dremel like the other reviewer said, maybe it's salvageable.