Contact Us Tel:(626) 286-0360 Store Locations
Phone Support M-F 7am-5pm PST
Browse by Type or Category
Free Shipping for Orders over $149. EPIC DEALS released daily!

Lonex Ultimate Upgrade Steel Spring Guide with Ball Bearing (Type: Version 6/7)

6 Customer Reviews

by Samuel V. on 11/10/2021
"This thing slaps, very durable, very neat.
by Levi C. on 05/31/2018
"
by Andr� E I. on 05/17/2018
"This is a great spring guide, just a heads up for M14 and P90 users.

The CYMA M14 actually uses a V.3 spring guide so this will not fit yours, so just go for the lonex V.3.

As for the P90, the shafts on the base are too thick (Not tall), and require too much force to fit correctly, so I recommend sanding down from the inside just a bit from one side and a bit more from the other, this way it will have one side that slides right in and another that gets stuck to make reassembly easier with the spring in.
Another option would be to get a V.2 spring guide for your P90 and it will fit without modification. It's been proven to work many times, only difference is shorter shafts but that's about it, you would see no actual difference.
by Mark Benedict S. on 04/03/2014
"I bought this as an upgrade for my G&P Magpul MOE carbine. It does not fit with the G&P gearbox, however, you can always do a modification of it, whether you grind the gearbox or the spring guide a bit to fit it in... and so far so good. Very sturdy spring guide.
by Thomas S. on 05/13/2013
"Much better than stock spring guide. My P90 one was made of clear cheap plastic with bubbles and did not have a ball bearing. This allows the spring to move around while the piston is cycling which lowers the chances of a spring snapping. Also, due to the free movement of the spring it may help increase rate of fire due to less resistance. I think it's great! It fit in with no problems.
by Eric L. on 07/15/2014
"I got thisfor my KA P90 Version 6 gearbox. A slight problem... The tabs sticking out the sides are too thick, and wont slide down into place properly. The tabs on the stock guide measure 1.5mm with digital calipers. This guide measures 2.0mm, and the clearance hole measures 1.7mm. It hits the back of the piston guide. I can modify it to work. But if it says "(Version 6/7)" it should work with a version 6 gearbox.. Just saying. Now, as for the rest of it, the bearings are so smooth its crazy. Not only does the back spin.. but over 80% of the shaft spins as well, excluding the tip. That is the main reason why I haven't sent it back, I will make it work. I give 3.5 stars because it didn't just fit in. If it just dropped into place 5 stars for sure.