(626) 286-0360
Airsoft
Fishing
Air Gun
A&K Trigger Grip Assembly for M249 Series Airsoft AEG
1 Customer Review
by Jonathan C. on 05/31/2012
"This is the stock grip that came with my Full Metal A&K M249 MKII.
PROS:
-------
It fits well in your hand tac gloved or not.
It has an easy open compartment that you could store a few extra 'C' cell batterys incase your equipment ran low on juice.
The trigger pull is easily adjustable for a longer/shorter draw.
CONS:
--------
Bescause of the build, the trigger gaurd has a slight side to side wiggle to it. I fixed mine by applying some Epoxy on the inside ( a 30 min task once I saw the wiggle to finishing putting it together)
The trigger is mounted to the stock via a hex screw holding the front "swivle" section up and a rear pin. When removing the rear pin the grip should swing out but it does not. If you look at the images you can see that the front top of the grip is flat and not rounded. It took 5 mins with a dremal tool smoothing it out so it swings open when removing the back pin without needing to pull the gearbox out.
All in all this is a sturdy grip and should be one of the last things you look at replacing on your m249.
INUONI, Member of : Team OHA, Whidbey Island, WA
PROS:
-------
It fits well in your hand tac gloved or not.
It has an easy open compartment that you could store a few extra 'C' cell batterys incase your equipment ran low on juice.
The trigger pull is easily adjustable for a longer/shorter draw.
CONS:
--------
Bescause of the build, the trigger gaurd has a slight side to side wiggle to it. I fixed mine by applying some Epoxy on the inside ( a 30 min task once I saw the wiggle to finishing putting it together)
The trigger is mounted to the stock via a hex screw holding the front "swivle" section up and a rear pin. When removing the rear pin the grip should swing out but it does not. If you look at the images you can see that the front top of the grip is flat and not rounded. It took 5 mins with a dremal tool smoothing it out so it swings open when removing the back pin without needing to pull the gearbox out.
All in all this is a sturdy grip and should be one of the last things you look at replacing on your m249.
INUONI, Member of : Team OHA, Whidbey Island, WA