Contact Us Tel:(626) 286-0360 Store Locations
Phone Support M-F 7am-5pm PST
Browse by Type or Category
Free Shipping for Orders over $149. EPIC DEALS released daily!

Adjustable Hop Up Chamber for G36 series Airsoft AEG Rifles

8 Customer Reviews

by Alec S. on 07/18/2020
"Just wanted to say this will work in an Elite Force/Umarex UMP. Couldn't find a replacement for it anywhere else but this works.
by Aaron S. on 02/12/2012
"Installed this in my friends JG MK36c so that he could use the m4 magwell conversion kit. The bucking lock broke and has to use the stock one, which also broke. So right now he has a tie wrap holding the bucking adjustment wheel in place. It works well, we used the stock bucking as that seemed to be better construction. Also the pin that came with the stock hop up had a retaining washer and was slight longer than this kit so we used that as well. Works well though. Need a better bucking lock though.
by Blaine G. on 07/15/2020
"Bought for my classic army g36, couldnt find anything about the hopup for it so took a gamble with this one. It worked just the fins didnt rotate into the barrel so i had to loosen the barrel put the hop up unit in and then tighten. But works fine.
by Alisha A. on 04/02/2017
"everything was great besides the actual hop up tube was junk so reused my Tokyo Marui Hopup and replaced all the old missing parts. so not a total waste upgraded the Tokyo Marui worn out or missing pieces
by Craig H. on 01/12/2014
"I own a JG G36C and very fond of it. After a bit of target shooting I found my BB's were just falling out, and then the inner barrel slid right out. The lock ring actually broke and all the "guts" were not in place. I figured to get this kit to replace everything. The only problem I had with this kit is that the hop-up chamber has a diagonal angle and my original had a tube at the bottom where it meets the mag. My original has a hairline crack on the side so I used that along with the other parts to get me back into working service. When I first got my 36, I was shooting around 390 fps, but with the crack, I'm lucky to make 320fps. Going to see about the metal chamber on this site.
by Matthew L. on 03/09/2016
"Like everyone else below me, I too had to sand down my nubs on installation, which was weird because this is a JG hop up that I was installing in a JG barrel assembly. Ok. So I finally sanded it down to where I needed it, but it still had issues even after that. Not very pleased with it over all. There are better hop-ups out there, I suppose the trick is to save a little more for the performance. You get what you pay for.
by John G. on 06/09/2015
"Bought this for my HK G36KV. After trying to install it just wouldnt work. The tabs on the end, that goes into the gun are to big. After filling them down to get them in, i wound up going to far and now it doesnt work at all. So if your buying this for the G36 KV, it doesnt fit.
by Lisa L. on 03/02/2015
"i have ordered this product for my KWA g36 c
it arrived in great time but when i assembled it i did not fit my gun... i needed to sand down the nubs that go in and twist inside the outer barrel. after sanding it down it so far works fine but it still bothers me, they said it was compatible with kwa g36 guns. but i guess they are not.