Contact Us (626) 286-0360 Walk-In Superstore Daily Deal
Extended Holiday Phone Support M-F 7am-6pm PST
Browse by Type or Category
HAPPY HOLIDAYS - 25% OFF (exclusions apply, see details)   Use code: NEWLOOK

Angel Custom Ultimate CNC Hopup Chamber for VSR-10 Airsoft Sniper Rifles (w/ Bucking)

6 Customer Reviews

by Jacob K. on 11/10/2016
"I had this Hop-Up in a Well MB07 and swapped it to a HFC VSR10 CO2 let me tell you this is the most reliable and achieves superior accuracy to the standard Hop-up. With the gas sniper i was hitting note book paper at 300ft CONSISTENTLY! Well worth the buy and the upgrade
by Jason C. on 12/11/2012
"A must have if you plan on increasing the inner barrel length of your VSR! I installed mine along with a 590mm 6.01 tightbore, also from Angel Custom, using the hop up rubber it came with, and it can achieve way better groupings than the stock barrel and hop up unit. Also this will allow you to use AEG barrels and hop up rubbers, which come in a greater variety of lengths than the proprietary VSR barrels out there.

Pros:
Much cheaper than PDI version
More versatility when it comes to inner barrels
High quality lightweight metal
Nice red anodized finish

Cons:
None!
by brice s. on 02/15/2016
"NOT a fan serious modification needed for VSR-10 Mb07 platform had to mill down a few 1000s of an inch for it to fit ..really not a recommended..or needed just change the bucking-and barrel for better performance.
by Jack L. on 03/17/2015
"Does NOT fit the VSR-10 spec MB03, it's extremely tight and needs to be forced, the mechanism/piece that hold the mag release spring wont fit on the hop up itself either, the hop up is too wide.
Really disappointed with this product, claiming it's VSR-10 compatible yet it doesn't fit an MB03.
clearly others have had bad experiences as well.
by Daniel B. on 02/26/2015
"It will not fit inside the TSD SD702 outer barrel without major modification. It's outer diameter is bigger than the outer barrel housing it's supposed to fit into.

Like others have said, The metal piece that is supposed to engage the bb release in the mag is too short.

The alignment for installing the hop up adjustment was off. the slot was too deep making the hop up lever like it was set at full adjust and still barely able to install the retaining pin.

This might be ok for some models but not for TSD sd702.
by Jorge V. on 05/05/2014
"Well this seem like a good hop up chamber specially for the price, I installed it on my tokyo marui vsr 10 g-spec along with a 6.01 430 mm angel customs barrel and now my rifle won't feed bbs. There seems to be some specification variation with the bb wedge release as it will not feed bbs into your gun. Waste of money this was, this should not be advertised for tm vsr10 as it doesn't work.