Contact Us (626) 286-0360 Store Locations
Extended Phone Support Hours 7am-7pm PST
Browse by Type or Category
Airsoft Season! SAVE 18% with coupon code: SUMMER2018 (Exclude MAP and SALE Items)

Reinforced Fill Valve for WE / AW Custom / HFC / KJW Airsoft GBB and GBR Magazines

7 Customer Reviews

by Isaiah F. on 06/28/2017
"Stopped leaking in HFC Broomhandle magazine.
by Justin J. on 10/18/2016
"Great valve all valves are delicate but these ones hold up the longest for me ive had one last up to 3 years
by Dustin B. on 07/03/2015
"I just installed these in 3 of my mags and could not be happier! All of my mags where leaking from the fill valve and this was an instant fix.

Cheaper than getting a new mag
Very easy to install
Perfect seal

The only con that I can see is, during the first mag fill the small o-ring around the fill stem popped out. It was easy to reinstall but I'll have to keep an eye out to make sure it does not happen again.

Very good and easy to install part. If you have a leaky mag, spend the $7 for this before dropping the $20 on a new mag!
by CHRISTOPHER C. on 09/12/2012
"Valves fit my WE m9 Magazine like a charm. I had to replace my old one because I had tightened it too much and snapped the head. be careful when replacing to not over tighten it. GREAT BUY!
by John M. on 05/26/2012
"These valves are cheap ($$ wise) and work fine. Just a word of caution though - when installing them do not over torque them or use a lot of force to screw it in... you will snap the head off of it and be boned. if this happens, take the mag apart, and use needle nose pliers from the inside of the base of the mag to slowly get out the busted valve. Hope this saves someone the pain I have suffered while snapping 2 of them.
by Roland B. on 04/23/2018
"These are good for we-tech mags but they unfortunately do not fit for Tokyo marui mags
by Jesse L. on 12/04/2015
"These are fragile. Do NOT apply very much torque during installation. They are liable to break. If you successfully install one, it will preform admirably.