Contact Us (626) 286-0360 Store Locations
Extended Phone Support Hours 7am-7pm PST
Browse by Type or Category
Airsoft Season! SAVE 18% with coupon code: SUMMER2018 (Exclude MAP and SALE Items)

Fighting Cat Front Assembly for WE G&P WA KA M4 Series Airsoft GBB Rifles

1 Customer Review

by Michael F. on 04/16/2015
"Well not very happy with this for one main reason that makes this entire assembly pointless.

The outer barrel that fits into/through the upper receiver, where the hopup will sit, isn't grooved. What's that do? It makes your hop up twist, slide back and forth, and ultimately doesn't hold your hop up into place like it should. This creates several problems. First and worst is every time the nozzle pulls back and fourth, the hop up moves with it, vs' the hop up staying put. Also,, the hop up twisting not only prompts difficult mag changes, but the slight amount of twist (once mag is seated) prompts inaccuracy. Sure in cqb settings you aren't typically worried about accuracy past 100 feet. But still.

Also in my G&P VLTOR upper receiver, the outter barrel sits slightly left from the RIS. The suppressor end threads to the outer barrel until it is firmly seated about 1/8th of an inch into the RIS. Because of this misalignment, the suppressor won't seat into the RIS properly. The rest of it is a decent design. THe barrel nut has a double barrel nut, that the RIS then threads into. THe double barrel nut design makes it easy to have the RIS sit perfectly verticle like it should. If it doesn't, you can adjust it.

Ultimately because of the fact that it won't even hold the hop up, at all, I am forced to either replace the outer barrel and hope the replacement barrel is the same length to fit the flow of the suppressor position, or replace the entire thing completely. I.E. this set up has been rendered useless. Recommend you try a different one!