Reviews: Reinforced Fill Valve for WE / HFC / KJW Airsoft GBB and GBR Magazines

$7.50 $6.38

3 Customer Reviews
Model: Parts-WE-FillValve
Location: Z1-003

Displaying 1 to 3 (of 3 reviews)

by Dustin B. on 2015-07-03 10:36:10
"I just installed these in 3 of my mags and could not be happier! All of my mags where leaking from the fill valve and this was an instant fix.

Pros
Cheaper than getting a new mag
Very easy to install
Perfect seal

Cons
The only con that I can see is, during the first mag fill the small o-ring around the fill stem popped out. It was easy to reinstall but I'll have to keep an eye out to make sure it does not happen again.

Overall
Very good and easy to install part. If you have a leaky mag, spend the $7 for this before dropping the $20 on a new mag!
by CHRISTOPHER C. on 2012-09-12 17:59:25
"Valves fit my WE m9 Magazine like a charm. I had to replace my old one because I had tightened it too much and snapped the head. be careful when replacing to not over tighten it. GREAT BUY!
by John M. on 2012-05-26 00:30:53
"These valves are cheap ($$ wise) and work fine. Just a word of caution though - when installing them do not over torque them or use a lot of force to screw it in... you will snap the head off of it and be boned. if this happens, take the mag apart, and use needle nose pliers from the inside of the base of the mag to slowly get out the busted valve. Hope this saves someone the pain I have suffered while snapping 2 of them.

Displaying 1 to 3 (of 3 reviews)