Contact Us (626) 286-0360 Store Locations
Extended Phone Support Hours 7am-7pm PST
Browse by Type or Category
Airsoft Season! SAVE 18% with coupon code: SUMMER2018 (Exclude MAP and SALE Items)

APS M4/M16 Trigger Wire Set w/ MOSFET - Rear Wired

4 Customer Reviews

by Peter Z. on 12/10/2017
"So far So great, I had a basic APS wiring and the fuse popped. I decided to get this because I needed a mosfet and I honestly was too lazy to hardwire a chip to the gearbox. was a simple install. If you take the slightest pressure and bend the motor-connecting pins, they won't snap or break off. After the installation, works amazing with 11.1V. I could tell the trigger responds much faster, and I'm saving the trigger contacts in the process. Awesome!
by Reuben L. on 02/15/2017
"Over all works pretty good. I am happy with it the only thing is you just have to be careful when putting it in the wiring is a little fragile. But other than that it performs really well.
by Liam M. on 07/21/2014
"Not happy with the wiring at all the black connector snapped when fitting into the grip. It was also causing a hard time to put my trigger in.
by Paul H. on 01/19/2014
"Not happy, the connectors for the motor are weak and thin. When bent to fit in gripe after attached to motor the connectors broke. Also for rear wired set up, where the heat shrink and connectors are located is where you have all the tightest spots. Made a hassle to get in the rear adjustable stock post.