Contact Us (626) 286-0360 Store Locations
Extended Phone Support Hours 7am-7pm PST
Browse by Type or Category
Airsoft Season! SAVE 18% with coupon code: SUMMER2018 (Exclude MAP and SALE Items)

Airsoft Systems ASCU Fire Control System for Ver 2 AEG Gearbox

3 Customer Reviews

by aaron b. on 01/29/2013
"Excellent unit thus far, I use it in a G&P M4 with M16 stock and lonex gearbox and motor. I have used it for one day of play and I have to say that the 3 shot burst is a fantastic feature, very controlled, accurate fire. The sensors also are very good at detecting malfunctions in the gearbox, while installing the unit the wiring was a major headache and once everything was where it should have been I attempted to test fire and it gave me a fault code. Turns out I pulled the trigger plug out while installing the lower gearbox locking pin, the unit recognized the problem, took the power away from the motor and sent a code to alert me, I will be using this in all my future builds.
by thomas b. on 03/18/2012
"hey everyone, i bought this mosfet and installed it with some trigger shims so the trigger sits right on the microswitch, i LOVED this mosfet , it felt nice and crisp , but on semi the trigger response couldent keep up like a systema could
by Luke K. on 10/05/2012
"Great system, it really is "smart" like it claims, when i plug in the battery it spins everything back and forth a little bit and finds the perfect spot to begin each cycle, and no matter how fast you pull the trigger in semi it always finds that same spot again, only bad things so far, is the wires are too fat and weak/floppy (its hard to get them to stay down in the gearbox, i cut one pulling the motor out), and the motor plugs pulled right off on me.... gonna try to snip the wires from the unit and solder on nice wires and start from scratch.

Also, its nice to not have to frig with all sorts of little springs and latches and things in the gear box, just screw in the trigger group, throw in your gears, put your cyclinder assembly and tappet plate in, and your all set, no need to anti-reversal latch or other stupid things that want to fall out when joining the gearbox shell.