Reviews: MAGPUL Magazine Assist - 7.62(.308) M14/KG3 - OD Green (3 Pack)

$9.89

This item is currently Out of Stock

2 Customer Reviews
Model: MAGASSIST-MP02x3-OD
Location: SF-034*

Displaying 1 to 2 (of 2 reviews)

by Walter K. on 2015-01-08 16:25:29
"Meh, they are a little hard to put on, but not bad. Granted, I put them on CMI (Checkmate ) 25 round mags for my Springfield M1A, so it might be different for an air rifle mag. I put it on one side, both edges and pulled it across to catch on the other side. I then stuck my index finger inside the corner curve of the rubber edge and pulled each corner down, going around and around. When half way down, or thereabouts, I could then get my index and middle finger inside the edge sides and then pulled down and in about 5 minutes had it on. During this process, when you pull down, it only goes down a tiny bit so be patient, it's working. I brought it down until the edges were flush with bottom of mag so the sharp mag corners will not scrap my hand/fingers, cuz that ouchie is like getting sliced with a dull knife.

If you're at the point of frustration, you might want to use a hair dryer to heat it up, I do that with rubber finger grips I put on my pistols. New rubber that hasn't been stretched yet is stubborn.

I HIGHLY recommend this item, I have them on all of my M1A mags. It is worth every pain and cuss word experienced in putting them on.
by Logan S. on 2014-09-25 16:58:37
"I do enjoy having these. They give better grip onto your mags and give a great tab to grab onto while they are in your mag pouches. WARNING: these are VERY difficult to get onto 7.62 mags. I have an SR-25 which is a pain to get on. these fit great onto .308 mags such as the AWM (AWS or whatever similar name). These are great for the Evike custom BAMF mid cap mags, because the lip on the mag is larger.

Pros:
VERY snug fit on mags
tough material
reinforced figertab

Cons:
very tough to put on

Would recommend if you know the mags well

Displaying 1 to 2 (of 2 reviews)