ID: 63279 (Stock-ICS-MA-364)
Hover or touch above to zoom
MAP ProtectedExempt From Coupons
- Injection molded polymer construction with metal alloy reinforcements
- Fully adjustable length of pull and cheer riser allows shooter to dial in the stock to their needs
- Easy to use, large, click wheel adjustments
- Fits over standard M4 retractable stock buffer tubes
- Comfortable rubber butt pad
- Integrated QD sling points
10" - 11" AdjustableCompatibility:
M4/M16 series Airsoft AEGs with standard retractable stock buffer tubesMaterial:
Injection molded polymer, metal alloyManufacturer:
(Write a review)
"This one its so good I install it and I have around 1k round on it and its great, everyone look at it like its a Magpul and it perform great.
"One correction to my review of this stock, the bar I cut does support the butt pad when you extend it out, after cutting the bar will be too short to extend the stock fully. This is not a problem for me as I would much rather have the increase in battery space then the extended stock.
"This is a great addition to your DMR. It is solidly built and much cheaper than the Magpull stock of similar design. But it does have a few issues, You must use a buffer tube to mount this stock, it uses a set screw to hold it to the tube, the screw is long enough to go down into the first lock hole on an ICS buffer tube. The set screw holds the stock firmly. On other manufacturers buffer tubes the set screw will protrude out of the bottom of the stock which can snag your hand or glove, but in newer releases ICS has provided two set screws of different lengths, so just use the shorter screw. The major issue is metal bar on the top of the rear stock cover, when you put the cover back on, this bar protrudes into the battery compartment, making the battery space even smaller (this cost me a brand new lipo battery as the bar hit the cells and shorted it out). The only purpose this bar serves is to give threads for the screws that hold on the but pad to bite into. My solution to this was to cut the bar using a Dremel tool and cut off wheel. I marked the bar where it came out of the plastic, held it in a vice and cut to the mark. This in no way affects the locking of the but plate and gave me an extra 5/8" in the battery compartment.
Discuss about ICS UKSR Adjustable Sniper Rifle Stock for M4/M16 Series Airsoft AEGs (Color: Black) with your friends and fellow Evike.com shoppers!
Comment or answer questions for a chance to win awesome prizes.
Details can be found on the Evike.com Facebook page.
Remember to check "Also post on Facebook" to qualify for the giveaways!
Have an urgent question about this item? We monitor these comments daily, but it may be faster to email us directly or call us at (626) 286-0360. Our resident experts are standing by to answer your questions!