ID: 49988 (Stock-VSR10-01-15)
Hover or touch above to zoom
No Payments + No Interest if paid in full in 6 months through PayPal Credit. Simply check out using PayPal and select PayPal Credit!
- Constructed with nylon fiber material
- Simple installation for VSR-10
Olive Drab Length:
Nylon Fiber, MetalPackage Includes:
Stock mounting hardwareManufacturer:
California residents click here for Proposition 65 warning
(Write a review)
"After receiving this body for my TM vSR 10, and trying to get the body to fit into the stock, i quickly realized that the magazine well needs to be dremeledo ut a few millimeters in order for the mag to fit. Also, after spending 2 hours trying to get the VSR internals into this body, and then doing research, i am missing the 3 extended body screws that are suppose to come with it, that did not. Evike advertises this product as "simple installation" yet you must modify the body a CRAP TON in order to get everything to work correctly. then they send it missing screws. not worth the 180 bucks. stay with the stock VSR10 body, a lot less hassle.
(modelworks website, showing it with all of the screws its suppose to include)
"Just got this today. I love it. I will put pros and cons for you to decide if you want this or not but i will say it is well worth the money. Fits near perfect with the JG Bar 10. I say near perfect because there is a little area on the back of the receiver where the screw the stock came with was not long enough to reach but that is ok the other screws it came with holds the upper assembly sturdy and secure. The other issue is you will need to sand down the mag well just a bit for the magazine to fit.
Easy to put together
Heavier than the plastic stock
No rear sling stud
"A great addition to my Bar 10! Although this is perfect, there are some flaws. When I started to install it, I had (and still have) an issue with the stock mag release. The button gets stuck and is hard to release. I would recommend getting an aftermarket mag release. Also, if you tighten the center stock pin too much the bolt will not pull back. It was a hassle to get the pin that connects the trigger guard to screw into the correct spot, but it works. When I installed the cheek riser, I had to use pliers to get the adjustment pins on because the threads weren't fully drilled through the stock. Another thing is the bolt handle, you have to shave down the slot for it slightly so it fits in snug. Other than that, I love this stock. The weight is perfect and it keeps my rifle steady. The stippled grips on the sides are a great touch.
- Looks cool
- Slightly heavier than the original stock (Could be a pro or con)
- Feels good
- Well made
- Some pins came pre-installed
- Had to shave two areas down (Mag release hole, Bolt handle slot.)
- Stock mag release doesn't work very well.
- Cheek raiser screws were hard to put in.
-Not exactly a 'perfect' fit, requires some modification.
Discuss about Modelwork M40A3 Stock for VSR-10 System - OD with your friends and fellow Evike.com shoppers!
Comment or answer questions for a chance to win awesome prizes.
Details can be found on the Evike.com Facebook page.
Remember to check "Also post on Facebook" to qualify for the giveaways!
Have an urgent question about this item? We monitor these comments daily, but it may be faster to email us directly or call us at (626) 286-0360. Our resident experts are standing by to answer your questions!