"Hands down, this is the best rifle to buy for those who want a big gun but also want to run a bit. It is light for a big gun, weighing in at about 10-11 lbs. It's very solid. I had it on a sling on my back while running to our next objective. When I took a turn with it, the sling caught a door and ripped off. The whole thing slammed into the ground. I suffered more trauma than the gun did. Everything still worked just fine. Not a scratch.
This L86 feeds like a champ with flash mags. It eats through them like a fat kid at the candy store. Every time with no jamming, no misfires, and without complaining.
This gun is accurate and consistent. The hopup needs a little fine tuning, but once you click it into it's sweet spot, you're hitting your target every time. The closest gun I have owned to this for accuracy would be the G&G m14 veteran. I would take this L86 over the m14 in any accuracy shooting competition.
The bi-pod on this gun is amazing. It swivels from side to side, so you don't have to reposition it when you want to shoot people who are running off to the side. It also adjusts height easily and tilts from side to side. Also, it makes a good makeshift front grip for when it's running and I want to hip fire the L86.
The iron sights are good. You can remove them and put on a rail for adding different optics. I switched it out for a scope at first, but then I missed the convenience of having a carry handle and soon put the iron sights back on.
The vertical grip in the back makes using the bi-pod your main objective while playing. You just set up the bi-pod, raise the shoulder rest, and then use the back grip to steer the L86 while firing like a mad machine gunner. It allows you to have more control while you are moving the gun while you are firing from the deployed bi-pod position. It also makes for fun jokes when you tell your friends that your gun goes: Barrel, trigger, mag, vertical front grip, then the stock from the front of the gun to the back.
This gun is also easy to work on. Need to change the spring? No problem, 5 minutes and no tools needed. Just pop out the two pins and remove the gearbox. Then remove the spring pin and replace the spring. It's that easy. The spring guide also has 3 settings so that you can adjust your fps a little when going to fields with weird FPS rules. For example, switch it from 415 (high) to 385 (low) on an m120 spring to get it below 400 FPS. Low setting on a m100 spring shoots at about 309 fps which is what I use when I go to CQB fields. With an m100 spring, I was still shooting as far as the average airsoft player in outdoor fields. I did not feel hindered by my lower fps even though I had forgotten to bring my m120 spring.
Quick change spring
Long inner barrel
Best bi-pod on the market
Only 36" long
Easy to lift and maneuver
Does not jam (don't invite it to play in your band)
Gets you attention on the field
Does not like Earl grey tea in the gearbox. "My $0.02 on the ICS L86.
This is one serious airsoft machine. Opponents will think twice before engaging you and in the right hands this thing will tear up a battlefield. I have had my L86 since 2013. It is very reliable as both a DMR (it has the same barrel length as my Echo 1 M14!) and a light support weapon, if given the right magazines (I use an Echo 1 850 round mag if I play light support). I have modified my L86 with the ICS rail for optics and a rail I have fitted to the right of the gun (I disassembled it and put a polymer M4 hand grip rail in the holes beside the iron sights). Unfortunately, these are the only rail-estate options at the moment that don't require permanent modification to the replica.
Speaking of disassembly, this thing is a piece of cake strip down. It is very easy to maintain the gearbox thanks to a removable spring guide and ICS has built the internals like a tank. It comes pre-installed with an M120 spring, well shimmed and well greased right out of the box. The motor is a short-type ICS Turbo 3000 (which has neodymium magnets like the ones from high end aftermarket motors, such as Lonex).
The back grip can be removed with 1 screw. If you play your cards right you can put it on the front of the grip by attaching a washer to the screw and closing the hand guard. It is tricky but it can be done. Be warned though, it will scratch the plastic.
The flash hider can be removed but it is bulky and longer than normal flash hiders. It is large because the front support rail and the bipod clamp onto it for stability and support.
- Built like a tank.
- It will handle any gearbox upgrade you can put in it.
- Nice external finish, high quality plastic.
- Can hit targets at 150 feet. Longer with some upgrades.
- Scares the snot out of new players
- Receives lots of attention at airsoft fields.
- Looks like a boss when you put rails on it.
- Very easy to use and maintain.
- Disassembly is a piece of cake
- Can adjust FPS without opening the gearbox
- Easy to swap motors
- Takes M4 magazines
- Electric harness design may prevent the use of a MOSFET
- It is power hungry. Be sure to have 2 batteries per all day event.
- I honestly can't think of any other cons...
If you want an airsoft gun that truly catches your attention, can be used as a semi-automatic sniper or spew rounds down the field, and you require nothing but the best out of the amount of money spent in an airsoft gun then the ICS L86 is a serious contender. Don't take my word for it though, take my friend's words for it. They have the scars to prove it lol. "I have owned this rifle for almost a year now. It is by far my favorite AEG so far. Being a bit power hungry I have installed a few upgrades like a 610mm EDGI barrel, maple leaf and SP140 spring. The internals handled all of it great, and reached 200-250 foot man sized shots.
Solid Externals and internals
adjustable and quick change spring
lightest support gun out there and can run DMR as well
Very crisp trigger mechanism
Extremely easy to work on
Compatible with Version 2 cylinder, cylinder head, piston, and gears.
Battery replacement is very easy
The nozzle is weak and prone to break during gearbox removal and installation
Motor connectors are very weak (easily replaced or soldered though)
Aftermarket flashhiders/mock supressors would require some very creative work to mount
Magazine well is longer than normal. Makes adding drum/box mags challenging
Drum and box magazines are awkward and cumbersome Read More Reviews Write a Review
« Back to product description
ICS Full Metal L86A2 British Military Full Size Airsoft AEG Rifle Features: Steel, aluminum & industrial polymer construction Carry handle integrated with rear detachable iron sights Realistic steel receiver, bipod, and barrel handguard Inner Barrel:
450 round hi-cap included. Compatible with Matrix, ICS, Tokyo Marui and other similar M4 / M16 Series Airsoft AEG Magazines.
375~420 FPS (Measured with 0.20g BBs)
ICS Metal Gearbox (Custom)
9.6v Small Type recommended (Battery not included. Wired to the front)
Gun, Quick Release Bipod, Magazine, Manual, Cleaning Rod
Wanna chat about
ICS Full Metal L86A2 British Military Full Size Airsoft AEG Rifle?
Have questions about this item? We monitor these comments daily, but it may be faster to
email us directly or call us at 1-626-286-0360.
Facebook about THIS with your friends! Comment for a chance to win awesome airsoft prizes. Details can be found on The Evike Facebook Fan Page HERE! Remember to leave "Also post on Facebook" checked to qualify your comment!