Action Fans "Cyclone Mike" Cooling / Anti-Fog Sport Fan Kit

3.9 stars, based on 7 reviews


Model: Kit-AF-CM

7 Customer Reviews

by Brett T. on 09/24/2015
"The Good: After adjusting it correctly, it does it's job "perfectly". It lasts many hours of straight gameplay, and takes either 3 or 4 AAA batteries. I will go on record to say that this fan, with or without the Revision Anti-Fog, is absolutely the ONLY thing to ever work for me. Most Sprays/Wipes/DIY methods will help deter fog only 10 minutes longer than without it at all, for me. I sweat A LOT, whether it's 30F outside or 90F outside. The Wipes worked the best for me, however instead of Fog it goes straight to WaterWall. Either way I'm essentially blind. The Fan however, keeps the visor both Dry and 100% the same temperature as the outside air... thus preventing Fog/Condensation buildup. It's pretty quiet too, but it's unlikely you'll hear footsteps if someone is trying to sneak up on you. I can still hear bbs rattling, gun parts, branches snapping, etc with the fan on though. I just can't hear people who sneak very quietly with the fan on... with it off I can hear them. I think most of the "noise" is actually vibration though, jumping around through my helmet. I can't actually hear the fan itself. So it could be my helmet's plastic shell is too thin and... well... that's my fault.

The Bad: No Velcro patches come with the power supply part, but it does come standard with the actual Fan.

The Ugly: So, there are some Tricks you have to perform if you want it to function as expected/desired. You can't just shove it anywhere into your helmet or goggles, for starters. The best setup I've found, is mounting the battery compartment on the back right or back left side of a FAST type Tac Helmet, then mounting the Fan on the Middle Right or Middle Left side. Then take the rubber tube, and run it into your goggles. The smartest thing to do, is measure how much hose you actually need, with half an inch to spare, and cut the rest off. SAVE IT just in case you need to reattach it. Loctite+Gorilla Tape will ensure it stays on there and with no leak if you do reattach it. Now what matters, is where the end of that hose is pointing and sitting in the goggles. I took one of the vents in the top right of my goggles(aligning the pack/fan/tube all to the rightside for me) and made it wide enough to have a snug hold on the tube, but not pinch it or reduce airsflow. I shoved the tube in, and with the way it wrapped around my helmets front edge and the direction it came from, it pointed directly at the lens forcing all of the air to slightly right of the middle of the lens. It stays 100% dry at all times, no matter how much I sweat. I can have a small shallow puddle of sweat in my goggles, and they'll otherwise stay 100% clear.

Overall: I don't regret buying this one bit. It does it's job very well. Yes, it does take a smidgen of tinkering, but if you refuse to tinker or just can't, you probably shouldn't be playing Airsoft. Everything requires some finesse at some point.

If you don't mount it right, it won't work to it's maximum efficiency. When you do mount it right, it's pretty amazing.
by Troy M. on 08/25/2015
"Two of my friends use this fan for airsoft and they say it works great! It keeps them fog free in even the most humid games. It only emits a slight amount of air so that its quiet and efficient. The construction is a little cheap but it works extremely well after each game my friends tell me to get one.
by David G. on 06/11/2015
"Isn't near strong enough for keeping the fog out of my welding helmet. Barely blows hard enough to blow out a match no matter what kind of batterys your using. I was told it will run up to 5 hours but mine barely runs 2 hours. Definately wasted $30!
Action Fans
Action Fans "Cyclone Mike" Cooling / Anti-Fog Sport Fan Kit

The Cyclone Mike is the most versatile mobile fan kit ever conceived. Highly adaptable and lightweight, the Cyclone Mike is perfect for almost any application. It serves as an Anti-Fog system to limit or prevent the build up of fog in work goggles and masks. It can also be changed over to a helmet and mask cooling system, providing a steady stream of air for up to 5 hours of straight use. The Cyclone Mike comes with everything you need except the 4 AAA batteries which runs the powerful fan. The Cyclone Mike is so adaptable, so versatile and so unique, Action Fans filed the patent on it.

  • Helps to prevent and eliminate fogging
  • Great for masks, goggles, helmets, etc
  • Velcro adhesive panel included
  • Complete unit, no assembly required

  • Batteries: 4x AAA (not included)
    Fan Dimensions: 55mm x 55mm

    Manufacturer: Action Fans

    Wanna chat about Action Fans "Cyclone Mike" Cooling / Anti-Fog Sport Fan Kit?

    Have questions about this item? We monitor these comments daily, but it may be faster to email us directly or call us at 1-626-286-0360.

    Facebook about THIS with your friends! Comment for a chance to win awesome airsoft prizes. Details can be found on The Evike Facebook Fan Page HERE! Remember to leave "Also post on Facebook" checked to qualify your comment!

    Items on Sale