ID: 41704 (Wiring-MTX-003-F)
Hover or touch above to zoom
Low Resistance Silver WiringMOSFET chip helps better regulate powerHeat Resistant Polymer prevents contact melting
Compatibility: For Tokyo Marui, Matrix, G&P and other compatible Version 2 Airsoft AEG Gearboxes
Connector Type: Small Tamiya
Material: Silver, Copper, Polymer
Disclaimer: Please use discretion when installing custom parts as fit and compatibility may vary. Some modification may be required. Professional installation recommended.
(Write a review)
"not bad at all it was a little tricky to install. i had to re solder it onto the original trigger contacts but that shouldnt be a problem even if your not that good at soldering just as long as you have a soldering iorn. it didnt work at first when i first assembled the gun completely, but after rearranging the wired a bit it worked just fine. and it did make the trigger response INSTANT. the only other mosfet i really tried was the krytac ones but this is honestly better. for the price you might as well try it out.
dramatically improves trigger repose
prevents trigger arching on semi
straight forward installation
tricky to work at first
may have to re solder it depending on your gearbox
its rather big but can fit in the top half of a standard m4 hand guard
overall if your looking for a mosfet and your on a budget yo cant go wrong with this
"Great kit for a good price. I re-wrapped it and its a nice board underneath. the mosfets aren't the greatest make, but it looks like three in parallel, with thick traces and decent lo-pro wire. I've run thousands of rounds at it with a 3s 90C battery and high torque motor with a 170 spring. Holds up fine, lol better than the gears do.
As others have stated the leads going to the grip well are just slightly too long, you will HAVE to cut and re-solder or else you face some very bad pinion meshing issues. Also make sure your selector plate contact is doesn't fall off or you'll blame the circuit, like I did heheh.
"Great wire kit.
The MOSFET was in a good condition when I received it, and the wires are very sturdy.
My only complain is that the wires are pretty long. I had to trim down some wires in the pistol grip, but other than that, this item is definitely 5-star-worthy.
Discuss about Matrix Wiring Switch Assembly w/ MOSFET for Ver.2 Airsoft AEG (M4 MP5 G3) - Front with your friends and fellow Evike.com shoppers!
Comment or answer questions for a chance to win awesome prizes.
Details can be found on the Evike.com Facebook page.
Remember to check "Also post on Facebook" to qualify for the giveaways!
Have an urgent question about this item? We monitor these comments daily, but it may be faster to email us directly or call us at (626) 286-0360. Our resident experts are standing by to answer your questions!