ID: 28258 (Gears-GE-02-06)
Hover or touch above to zoom
Fits for AEG II/III Ver, M85-M120 Spring Recommended.
Increases rate of fire.
9.6V Battery Recommended.
Material: Steel/Thermal Treatment
(Write a review)
"Well, these gears started off okay. They came nicely packaged, and appeared well constructed, though as the other review states, yes, you do have to sand down the gear shafts to allow them to fit in non-TM bushings. I installed the gears in my gearbox with proper shimming. They performed well, increasing my rate of fire and trigger response dramatically. However, this only lasted so long. Within under 500 cycles, four of the spur gears teeth snapped clean off. I am a bit disappointed.
1/5, would not buy again.
"these gears are great! i run these gears in my m249 with a m120. i also ran my m249 at 30ish rps and they did just amazing! the only problem i had with them is they where designed for marui type bushings so their gear shafts were to large for my bushing. but i sanded the shafts down till they fit perfectly.'
these gears dont fit non mauri type bushing( unless modified, and i am having some trouble with motor right now they keep burning brushes, i dont know if it is because of the gears or not)
Discuss about Guarder Steel High Speed Gear Set for Airsoft AEG Gearboxes. (Ver.2 / Ver.3) with your friends and fellow Evike.com shoppers!
Comment or answer questions for a chance to win awesome prizes.
Details can be found on the Evike.com Facebook page.
Remember to check "Also post on Facebook" to qualify for the giveaways!
Have an urgent question about this item? We monitor these comments daily, but it may be faster to email us directly or call us at (626) 286-0360. Our resident experts are standing by to answer your questions!