"Mediocre midcaps at best. Horrible feeding issues and no way to properly maintain them.
Fit in many guns
Cap for releasing spring for mandatory maintenance is glued on, made of the softest plastic I've ever seen, melts when you try to melt the glue and ends up ruining the mags
Dirty from factory
Overall, poor quality and terrible manufacturing decisions bring these mags down. 4/10
"Okay guys here's the rundown, I tried these mags in my G&G CM16 and they didn't feed at all so I put a patch of the soft side of Velcro in the front of the magwell to make them sit in better and bam, they feed perfectly. Just be sure to load them and unload them 3 or 4 times like with any other mid caps to break them in.
THEY FEED PERFECTLY
IF NOT USE SOFT SIDE OF VELCRO
BREAK THEM IN
"These Elite Force mags have been absolutely terrible. I run a Classic Army M15A4 and Madbull .20 BBs, and, at least with this setup, nothing seems to work.
First tried in the gun, only 1-2 BBs would feed, and then nothing. Got them out, tested them without shooting: still not feeding. The BBs wouldn't even eject out of the mag, they'd just stay stuck inside the mag. Tried lubricant, still didn't feed. Then thought maybe it was the spring, so I tried to open them up, and that's when the fun began.
Not only were the caps too tight, the plastic they're made out of is as soft as ice cream in a heat wave. Eventually, armed with a trusty over sized Flathead screwdriver, I just ripped the cap off, and pryed both of the halves of the mag off. Turns out the BBs just stay stuck in the last inch before feeding, probably because the spring is trying to get them in a single stack while the BBs are very firmly pressed in as a double stack in the mag.
Moral of the story: when a mag deal looks too good to be true, it probably is. If these worked for you, you must have some kind of awesome Karma.
So, to the listing!
They look pretty good
Heavy enough to serve as paperweights
The whole 10 of my mags didn't feed
Made of plastic
Are not smooth, sometimes they catch while reloading
Cannot be serviced (cap is too soft and tight)
Again, do not even feed.
So, final grade: 1/10. Just because they tried. But, trying isn't enough, especially when they cost 65$.
tl;dr: They don't feed, therefore, don't buy.