"To start, this is an amazing replica. I've fired the real thing on a couple of occasions and this airsoft version is incredible.
The over all look and feel is very good. The plastic of the fore grip being the only "cheap" feeling part of this gun in my opinion considering it is just a replica. The balance is great with the battery in the butt stock. Right out of the box the gun felt solid and tight just like the real thing. It chronoed at the store at the top end of the posted numbers. In fact, the first shot was at 351 fps, the remainder of the half dozen shots were between 338 and 345. Its been field chronoed twice, both times coming in at an average 340 and 343 respectively. So if you want a CQB gun, this is an excellent choice, but might be a little low for a field gun.
The metal hi-cap mag that comes with the gun fits good with just a little wobble, nothing terrible. There is plenty of room in the stock for a large battery. The one disappointing thing about the battery location is it allows the battery to flop around inside. Its a minor annoyance which I think can be fixed with some foam.
The manual is very simple as expected. The one item missing in this package is a scope mount. The manual actually shows one but its not included anymore I guess. I HIGHLY recommend that if you want to put a scope/optic on the gun that you use one similar to the one pictured in the manual. I got one of the NcStar mounts and it doesn't fit without major metal removal on the mount, I know because I tried and even with a mill and dremel, it still didn't fit well. I then purchased a CYMA M5 / T3 Low Profile mount (pictured in the manual) and it went on perfectly.
The iron sights are good and once zeroed, are accurate. I know that most people don't care for the stock iron sights but they do work. Being like the real steel versions though, they are tough to use with a mask or face shield on so get a good mount and optic. I went with a red dot w/ a cantilever mount. I reversed the sight in its mount to place the viewing side of the optic directly over the rear iron sight. This will leave some room up front on the rail for adding an optic shield, low mount laser, etc.
Here are my pros and cons
Good FPS out of the box for CQB.
Good ROF w/ 9.6v bat.
Didn't come with scope mount
Hand guard feels cheap
Mag wobbles in gun (minor)
Battery knocks around in stock (minor)
Conclusion: I was looking for a CQB gun that didn't need a huge amount of upgrades to make it work. This MP5 SD5 fit the ticket almost flawlessly. If you're looking for an accurate, well balanced, stock CQB MP5, I can't think of a better choice at the moment.
I did a lot of research online and in stores before I purchased this gun. I want to thank the people at Evike.com for answering all my questions (and there were a lot) and all their help. "Short Version: Any way you spin it, this is a fantastic gun. Performs well and has a solid feel. If you are into MP5's, this, along with the ICS one, is a fantastic choice.
I originally purchased this gun in October of 2013. Quick shout out to evike for their quick delivery and care in delivering the package. Anyways, the gun came in one of HK's regular "no compromise" boxes. Upon opening it up, everything was perfectly packaged and in its place. In the box is a cleaning rod, the gun, an instruction manual, 1 hicap mag, and the gun. Just note that the box is too short for the full gun to fit into, so there is a slot for the silencer to go when you screw it off, just in case you plan on using the box instead of a gun bag (I don't recommend this).
Anyways, as you hold the gun you will be impressed by the weight for an MP5. I estimate it to be around 8-9 pounds (my vfc scar-l is 7, and this is heavier). Now although the externals are good, they're not great. The bolt is wobbly and clinks around a bit too much. The upper receiver is a cast magnesium alloy of some sort with an uneven finish and doesn't seem to be of very high quality (not cheap, but not great). The polymer parts are somewhat cheap too, but maybe I'm spoiled with VFC nylon fiber. And of course HK has to engrave safety warning paragraphs into both sides of the gun. Thankfully, there is zero wobble anywhere but the bolt, but I dont recommend dropping this one. The magazine that the gun comes with is trash just like all MP5 hicaps, it wobbles around in the magwell and feeds terribly. My 2 cents is to buy some Matrix 90rd MP5 midcap mags here on evike to go with this gun, they fit perfectly with no wobble at all and feed like a dream. Personally, I think that MP5 iron sights are terrible and many people agree with me here, so buy an MP5 attachment rail and slap a red dot onto it.
Now for the part that everyone cares about, performance/internals. Gotta give this part a 5/5. With the Matrix 9.6v 4000mah battey (get this with it), I observed an impressive rate of fire, but more importantly, very good trigger response because of G&G's high torque motor. G&G hop up buckings are excellent so accuracy was spot-on, even when compared to to longer guns like the SR-12 and Scar-H. The top tech gearbox is very good, as it has 8mm bearings, steel gears, aluminum piston head, high quality wiring, and a decent piston. Shimming and AOE was good for a stock gun. The only problem I have with it is that the gearbox shell itself seems to have a little less reinforcement than I would have liked, especially since G&G decided to go with a metal piston head. Its not too bad and you wont have any problems unless you decide to pop a more than 400 fps spring into it. If it does break (unlikely), any version 2 gearbox will fit but you wont have the blowback. The blowback functions nicely and you lose surprisingly little compression. It is a nice touch. The hopup unit is a regular one-piece, black plastic MP5 style unit. It does its job, but evike sells some under their hop up section that are full metal so I recommend those. The barrel is standard MP5 length, which is somewhat disappointing since there is plenty of room inside the silencer for and extra 4 inches. I put a PDI 6.01 in it that stretches to the end of the silencer and got notably better groupings at 150 feet.
Anyways, this gun worth every penny of $229.99. You get outstanding out-of-the box performance and plenty of upgrade options should you wish. The externals could have been a little bit nicer, but they're by no means cheap. A few things I suggest getting with it are:
- Matrix 90 round MP5 midcap mags
- Matrix 9.6v 4000mah large type battery
- Scope mount
- Red dot sight
Happy Airsofting! "I have had this gun for over 2 years, and let me tell you, this is a fantastic gun. Through the years I have had it, I have never had an issue. I have put at least 40000 rounds through it and never had a problem. With the 8.4 volt large battery I use with it, the ROF is MENTAL. I often get yelled at for over shooting. One issue with this gun(in my opinion) is the fps. It only shoots around 330. That isn't too good when it comes to outdoor fields.
Here are the Pros and Cons:
It is an MP5
High quality build
Blowback is neat
Hopup works well
Doing the Hk slap with this is very satisfying
A little big for cqb (in my opinion)
The plastic on the top of the gun looks cheap, and you can see the mold things
Overall this gun is amazing and I would recommend it to anyone who would likes MP5s or beast guns. All you need to do is upgrade the spring and you are good to go. Read More Reviews Write a Review
« Back to product description
*Red Dot Scope and Scope mount not included H&K Licensed MP5 SD5 Full Metal Elite Airsoft AEG Rifle by G&G Top Tech
The Umarex H&K Fully Licensed MP5 SD5 is one of the best looking MP5 SD5's in the Airsoft industry. OEM is Umarex / G&G. The H&K MP5 SD5 comes with very detailed, laser etched trademarks, the classic H&K "Navy" style lower receiver bullet markings, a Full Metal detachable Mock Silencer, and integrated sling swivels. The internals are Full Metal and of the highest quality able to withstand the use and abuse expected of a Top Tier AEG. Muzzle Velocity: 330-350 FPS Materials: Aluminum Alloy, Nylon Fiber, Steel Overall Length: 775mm Weight: 2700g Inner Barrel Length: 229mm Magazine: 200rd Hi-Capacity Battery: 8.4v or 9.6v Small Type Recommended. (Battery not included) Package Includes: Gun, Mock Silencer, Magazine, Unjamming rod, Manual
Manufacturer: Umarex USA (Fully Licensed by H&K) OEM: G&G Top Tech Features
- Genuine, Fully Licensed Laser Etched H&K Trademarks
- Full Metal Upper Receiver and Outer Barrel
- Full Metal High Strength internals
- High Strength Nylon Fiber Stock, Pistol Grip, Lower Receiver, and Fore Grip
- Integrated Detachable Mock Suppressor
- Front and Rear Barrel Sight
- Textured Grip Handguard
- "Navy" Style Bullet Lower Receiver VIDEO
Wanna chat about
H&K Licensed MP5 SD5 Full Metal Elite Airsoft AEG Rifle by G&G Top Tech?
Have questions about this item? We monitor these comments daily, but it may be faster to
email us directly or call us at 1-626-286-0360.
Facebook about THIS with your friends! Comment for a chance to win awesome airsoft prizes. Details can be found on The Evike Facebook Fan Page HERE! Remember to leave "Also post on Facebook" checked to qualify your comment!